Expert Help & Advice: +44 208 543 9696 Custom Finance Options Available

My Infill Is Weak

Back to Knowledge Base

Your infill (the cross pattern inside your printed object) should more-often-than-not not be weak, and the biggest reason for this would be an overall failure to extrude properly; the necessary steps should be taken from the other help sections on how to clean out your extruder or you should make sure that your settings and amount extruded are proper for the nozzle diameter and speed which you are printing at.

If you want a sturdier Infill setting, check out the CraftWare section “Infill” located under the “Basic” tab after you click on “Slice”.  At this point you can chose your pattern, percentage and the thickness of each line, plus a few other more in-depth tweaks.

Call Now ButtonCall Now